Piper Cub J3

PIPER CUB J-3- Electric scale model
 

SKILL LEVEL - Intermediate
 

SPECIFICATIONS:

Length 704mm 
Wing span 1100mm
Wing area (dm2 ) 15.6 
Weight (g ) 450-550
Radio required 4ch 4servo+ESC
 

KIT INCLUDES

Laser cut balsa and ply for fuselage and wing construction
Elevator and rudder push rods
Control horns
Colour stickers
Construction guide book

The essential parts for realistic detail, such as cowling, dummy engine, seat, scale tires, windshield, side windows, are plastic molded and standard equipment. A large window is formed from a rib and spar layout identical to that of a full-sized plane.The fuselage has a dual layer construction with a service hatch at the bottom and space for the receiver and elevator and rudder servos.
The bottom nose hatch is for storing the
battery as well as the speed controller
(not included).
 

ADDITIONAL ITEMS REQUIRED

Epoxy glue                                                                               Cyanoacrylate glue                                                                                        Covering film
Tools (hobby knife, drill, needle tip pliers, scotch tape etc)
Radio set (more than 4 channels), 4 servos + ESC

Tahmazo Brushless Motor IR-201554 and GB200 Gearbox with 4:1,5:1,6:1 ratios.
Lipo battery

*The scale tail gear and foam wheels shown in the photo is not included in the kit.

ITEMS RECOMMENDED FOR USE WITH THIS KIT

---check our sites other catagories for these items---

Tahmazo servo TS-1002 x 4
Tahmazo Pro.C MAX ESC 1812-3s
Tahmazo 1000mAH 2s lipo
TY1 30 minute epoxy
 

The world renowned Piper J-3 Cub is now electric-powered and available as a laser-cut balsa kit. It has been produced at a 1/9.5 scale based on the wealth of information on the full-sized plane. The Piper J-3 Cub is scaled down from the full-sized plane not only in the layout of the wing and stabilizer but also in fuselage cross section based on the rib arrangement and pipe frame. A small model having a wingspan of 1100mm, the scale appearance of this kit also rivals larger models. All parts having intricate shapes, such as dummy engine, cockpit and seat, are plastic molded and standard equipment. The lightweight design with slight modification enables positive and stable flying.
 

NZ$122.10
Quantity